Installation Guide :
 
Please remove the original VGA cooler or heat sink, and apply the proper amount of
thermal paste on the GPU die.
 
Position the washer on each
of hexagonal screws.
 
Postion the graphic card on the screws and use and additional washer in each
instance.
 
Use the spring screw to fasten the cooling device.
(PS : Carefuly and evenly tighten the screws. Don't over turn.)
 
Connect the ventilator to the motherboard .
 
Finish installation.
Copyright EVERCOOL Thermal Co., Ltd. 2008. All Rights Reserved.