Take the attachd seal, then stick it on the one side memory that without 1C. (If the memory get 1C for both sides, you don't need to stick the seal).
 
Make the inlet of heat sink toward yourself, then put your fingers on the sides of longest heat sinkl (this heat sink without printing).
Use another finger to open the shorter heat sink slightly. (Don't do it too hard in order not to make it reverse easier).
 
Place the memory card in between the heat sink.
 
Insert them into the memory block.
 
Aim the fan clip at the track, then insert it. Your can adjust the fan position as your demand.
 
Connect the power cable .
   
Finished installation.
   
Copyrightc EVERCOOL Thermal Co., Ltd. 2008. All Rights Reserved.