HP-12025 Installation Guide
(01) FAN x1
(02) Clip for intel x4
(03) Screw for intel x8
(04) Black washer x8
(05) Cooler x1
(06) Rubber nails x8
(07) Nut (A) x4
(08) Screw x4
(09) Nut (B) x4
(10) Clip for AMD x 1
(11) Thermal grease x 1
  • Additional remarks

Intel LGA 1366 1156 Clip A supports for Intel LGA 1366/ 1156.
Intel LGA 1156 775 Clip B supports for Intel LGA 775/ 1156.
Suggestion: Clip A is more suitable for using with Intel LGA 1156
For INTEL 775
For INTEL-Pentium D/P4﹝LGA 775﹞/ Core i5﹝LGA 1156﹞/ Core i7﹝LGA 1366﹞
 
Put the washers on the screws.
 
Put the screw into the hole on the motherboard and put another washer on the screw.
 
Screw the nut 2 onto the screw and tighten it.
 
Repeat steps 1 through 3 to fix the other 3 screws onto the motherboard, and then evenly spread the thermal grease on the CPU surface.
 
Place the cooler on the centre of the CPU and be sure to pass the screws through the holes of the bracket and fix it.
 
Fasten each of the nuts 1 and screw them up diagonally.
 
Hook 4 rubber nails onto the cooler.Notice: rubber nails should be hooked on the side where the distance between the heat pipes is shorter; otherwise, it might affect the cooling performance.
 
Fit the fan with the 4 rubber nails and tighten the rubber nails.
     
 
Plug in the fan connector into the socket.
 
Finish the installation.
 
For AMD-Athelon 64/Opteron ﹝Socket 754/939/940/AM2/AM2+/AM3﹞
 
Remove the original bracket.
 
Evenly spread the thermal grease on the CPU.
 
Put the heat sink on the CPU, and buckle AMD clips with AMD plastic frame onto the motherboard. (PS: Pass the AMD clips through the square hole and above the copper pillar). Press the clips and fix them.
 
Hook 4 rubber nails onto the cooler.Notice: rubber nails should be hooked on the side where the distance between the heat pipes is shorter; otherwise, it might affect the cooling performance..
 
Fit the fan with the 4 rubber nails and tighten the rubber nails.
 
Plug in the fan connector into the socket.
   
Finish the installation.